how to clean intake manifold on 2004 accord
Honda Accord: Intake Manifold Removal and Installation
Exploded View
Removal
1. Do the battery removal procedure (see page 22-92).
2. Remove the front grille cover: Р'В© 2-door (see page 20-274) Р'В© 4-door (see page 20-274) 3. Remove the water separator (A) and the intake air duct (B).
4. Remove the harness clamps, then remove the battery base (see step 8 on page 5-3).
5. Remove the engine cover.
6. Disconnect the breather pipe (A), then remove the intake air duct (B).
7, Disconnect the evaporative emission (EVAP) canister
hose (A) and the brake booster vacuum hose (B).
8. Disconnect the water bypass hoses (C), then plug the
water bypass hoses.
10. Remove the intake manifold bracket
11. Disconnect the vacuum hose (A) from the intake
manifold.
12. Remove the Intake manifold (A), then disconnect the positive crankcase ventilation (PCV) hose (B) from the Intake manifold.
Installation
1. Connect the positive crankcase ventilation (PCV) hose (A) to the intake manifold, then install the intake manifold (B) with new gaskets (C), and tighten the bolts and nuts in a crisscross pattern in three steps, beginning with the inner bolt.
2. Connect the vacuum hose (A) to the intake manifold.
3. Install the intake manifold bracket.
4. Connect the manifold absolute pressure (MAP) sensor connector (A) and the throttle actuator connector (B), then install the wire harness clamps (C).
5. Connect the water bypass hoses (A).
6. Connect the evaporative emission (EVAP) canister hose (B) and the brake booster vacuum hose (C).
7. Install the intake air duct (A), then connect the breather pipe (B).
NOTE: When tightening the screw of the hose band (C), align the edge of the hose band (D) with the mark (E) painted on the hose band. If you tighten the screw over the mark, replace the hose band.
8. Install the engine cover.
9. Install the battery base, then install the harness clamps {see step 63 on page 5-22).
10. Install the water separator (A) and the intake air duct (B).
11. Install the front grille cover: - 2-door (see page 20-274) - 4-door (see page 20-274) 12. Do the battery installation procedure (see page 22-92).
13. After installation, check that all tubes, hoses, and connectors are installed correctly.
14. Clean up any spilled engine coolant.
15. Refill the radiator with engine coolant, and bleed the air from the cooling system (see step 5 on page 10-6).
See also:
Installing a Child Seat
After selecting a proper child seat and a good place to install the seat, there are three main steps in installing the seat: 1. Properly secure the child seat to the vehicle. All child seats ...
Rear Bumper Removal/Installation
NOTE: - Have an assistant help you when removing and installing the rear bumper. - Take care not to scratch the rear bumper or the body. - Put on gloves to protect your hands. - When prying ...
F-CAN Circuit Troubleshooting
1. Turn the ignition switch to LOCK (0). 2. Jump the SCS line with the HDS. 3. Disconnect ECM/PCM connector A (49P). 4. Measure the resistance between ECM/PCM connector terminals A3 and A4. ...
how to clean intake manifold on 2004 accord
Source: http://www.haccord.org/intake_manifold_removal_and_installation-837.html
Posted by: feathersheming.blogspot.com
0 Response to "how to clean intake manifold on 2004 accord"
Post a Comment